Download USER`S MANUAL

The scheme below shows the correct interpretation of the different case back inscriptions on your watch.
INSTRUCTIONS FOR QUARTZ WATCHES
RONDA CAL. 6003.D, RONDA CAL. 6003.B, RONDA CAL. 6004D, RONDA CAL. 6004.B
Case back engraving
Battery 373
(ø 9.5
mm, H 1.65 mm)
RONDA
CAL.
5030.D
3 ATM
Battery type: 395 (ø 9.5 mm x 2.6 mm / SR 927 SW)
Accuracy: +20 / -10 seconds per month
Crown position II
Date setting (quick mode)
An extreme acceleration in setting the date with quick mode can induce
a false date
indication. The synchronisation is re-established by setting
DESCRIPTION OF THE DISPLAY AND CONTROL
BUTTONS
the date from 01 till 31 (crown position II).
5 ATM
10 ATM
20 ATM
DISPLAY ELEMENTS
Normal function
Crown position III
CONTROL BUTTONS
Time setting
Watch stops. Energy saving mode (saving approx. 70%)
Case back engraving:
• 3 ATM: the watch resists to accidental contact with water and normal perspiration.
It means no immersion in water, neither for swimming nor aquatic sports.
• WATER RESISTANT 5 ATM: this watch resists to occasional immersion.
An annual control of the sealing gaskets is necessary.
• WATER RESISTANT 10 ATM: the watch is suited for all aquatic sports, except diving.
An annual control of the sealing gaskets is necessary.
• WATER RESISTANT 20 ATM: the screwed crown, the thickness of the crystal and packings have been especially
designed to withstand pressure of 20 atm. Make sure that the crown is entirely screwed, before you go into the water.
An annual control of the sealing gaskets is necessary.
Crown position I
MINUTE HAND
RONDA CAL. 7003.L
CENTRE STOP-SECOND
BatteryHAND
381 (ø 11.6 mm, H 2.15 mm)
HOUR
MINUTE COUNTER
Crown position I
Crown position II
PUSH BUTTON A
Normal function
Date setting (quick mode)
CROWN
During the date change phase between 11 PM and 1 AM; it is possible to correct the date (date must be set
to the following day !) An extreme acceleration in setting the date with quick mode can induce a false date
indication. The sunchronisation is re-established by setting the date from 01 till 31 (crown position II).
HOUR COUNTER
Crown position III
40 l www.rodania.com
Time setting
Weekday setting
Watch stops. Energy saving mode (saving approx. 70%)
SECOND HAND
PUSH BUTTON B
www.rodania.com l 45
DATE
RONDA CAL. 5030.D (continue)
50 l www.rodania.com
SETTING THE TIME
SECOND HAND
Pull out the crown to position III
(the watch stops).
Turn the crown until you reach the
correct time 08:45.
Push the crown back into position I.
Please note: * in order to set the time to the exact second , must be pulled out when the second hand is in position “60” (|).
Once the hour and minute hands have been set, must be pushed back into position I at the exact second.
SETTING THE DATE (QUICK MODE)
Pull out the crown to position II
(the watch continues to run).
Turn the crown until the correct date
appears.
Push the crown back into position I.
Please not:
During the date changing phase between 9 PM and 12 PM; the date must be set to the date
of the following day.
www.rodania.com l 51