Download NEO-BLN-0014 User Manual

NEO-BLN-0014 User Manual
Please read this manual carefully before using the fixture and keep it for your
Technical
Technical Specification：
Specification：
future reference.
1.1. Voltage:
Voltage: AC120V/60HZ
AC120V/60HZ230V/50HZ
230V/50HZ
Note:
2.2. Power:
Power:25W
25W
Caustic or deliquescent chemical can cause damage to the housing.
3.3. Fuse:
Fuse: 2A/125V
2A/125V1A/250V
1A/250V
The operation temperature must be below 40℃，humidity is 0~95％. If it is
4.4. Light
Light Source:
Source: 9x3W
9x3WUV
UVLED
LED
5.5. Dimension:
Dimension: L504*W78*H158mm
L504*W78*H158mm
6.6. Weight:
2.5KG
Weight: 2.5KG
used out of this range, the lifespan of the fixture will be shortened.
For Indoor Use
Warning:
Be sure that input voltage is same as rating voltage; deviation is 10%.
The fixture must be linked to the earth wire.
Do not dismantle the fixture, if there is any problem with the fixture, please ask
professional staff to repair.
Product Size：（mm）
Packing List

NEO-BLN-0014

User Manual-----------------------------------------------------------------------------------------------------------------------------------------1pc
0.5M LED UV BAR--------------------------------------------------------------------------------------------------------1pc
1/2
Introduction
NEO-BLN-0014 is a LED washer which is made of 9pcs 1w purple LED, it is used for replacement of traditional purple light. This
product is easy operation and easy installation, with a low price and well effect, especially suitable for the wash of Home Party and
Entertainment place.
Side View:
①Power Cable ②Fuse Holder ③ON/OFF Switch
Installation：
This fixture can be used on the flat surface or hanging on the wall or ceiling. If you want to hang it, please be sure that you have fixed the
screw on the wall or ceiling very closely to avoid any problems.
a) Flat surface installation
b) Hanging installation
Trouble shooting：
Problems
The machine does
not work
LED dimmed
Check list
Trouble Shooting
1. If your power is the same as the input of the
machine.
1. Make sure the voltage.
2. Replace the same fuse.
2. If the fuse is broken.
If your power is the same as the input of the
machine.
2/2
Make sure the voltage input.