Download snappi wheelbase interface workshop manual

Snappi Wheelbase & Interface Workshop Manual
Offer up the rear of the mounting
plate to the 3 bolts.
Fig 8.8.6
Position the plate such that the
bottom of the mounting place is
above the brake block (in the ‘off’
position), with the side of the plate
sitting vertically. Ensure that the
position of the bolts is clear of the
cylinder support (as the support is
curved, ensuring all 3 holes are at
least 1 inch from the fixing holes will
leave sufficient room for the fixing
screws).
When in a suitable position, press the
mounting plate against the protruding
screws so that the paint leaves a
mark on the place.
Fig 8.8.7
Document No: 053-02 v7
Page 36 of 46
Snappi Wheelbase Interface Workshop Manual.doc
October 2015