Download Printed in U.S.A.

Agrifab_A4_Lawn_sweeper.book Seite 8 Freitag, 4. März 2005 5:30 17
English
Drive slowly on uneven ground (danger
of overturning).
If the foreign matter (such as a stone) is
struck, switch off the engine of the
towing vehicle immediately. Check the
sweeper and towing vehicle for damage
and visit a specialist workshop, as
necessary .
Open fire or severe heat can damage or
even ignite the brushes and grass bag.
Keep the sweeper away from fire.
Wear safety footwear.
GB
User’s manual – Lawn sweepers
Every two years
Greasing driving parts
Clean and grease driving parts (refer to
“Maintenance”)
Detach wheel:
Storage
!
Caution
Grass and leaves in the grass bag can
develop a great deal of heat over a long
period of time and ignite.
Empty the grass bag before storing the
sweeper.
Emptying the grass bag
Clean the sweeper thoroughly so that
fungus and rust do not form.
Stop the towing vehicle and switch off
the engine.
Store the sweeper in a dry room.
Tip the grass bag from the towing
vehicle by pulling the rope (Fig. 1, No.
2).
If necessary (such as when space is
cramped), the grass bag can be folded
together. To do this, remove the two
braces inside the grass bag.
Tips on using the sweeper
A good result is achieved by sweeping
at a speed of approximately 5 km/h.
Experiment to determine the driving
speed at which best results are
achieved.
Models A and B (Fig. 5)
Remove the wheel cap (1) with a
screwdriver.
Remove locking nut (2) and washer (3):
Maintenance
Remove wheel. There is one washer (4)
behind the wheel.
Lubricate wheel bearings
Model C (Fig. 6)
(Fig. 3)
Mow the lawn uniformly before
sweeping the lawn.
Care and maintenance
Every time you use the sweeper
Check all screw connections for loose
fitting and tighten as necessary.
Inspect sweeper parts such as brushes
for damage (refer to “Maintenance”).
Visit a specialist workshop as necessary.
When you have finished
working
Empty the grass bag and clean with a
brush or broom.
Remove the wheel cap (1) with a
screwdriver.
Lubricate wheel bearings with a few
drops of light oil.
Remove the wheel cap (1) with a
screwdriver.
Lubricate the brush axle
Remove retaining washer (2) and plain
washer (3).
(Fig. 4)
Remove wheel. There is one washer (4)
behind the wheel.
Clean the housing of the sweeper with
a soft brush.
(Fig. 7)
String or the like may wrap itself around
the brushes or brush axle while you are
working. Remove it carefully.
Once during the season
Lubricate the wheel bearings (refer to
“Maintenance”).
At beginning and end of season
Lubricate the brush axle (refer to
“Maintenance”)
8
Lubricate the brush axle with a few
drops of light oil.
Clean wheel housing and driving parts
(remove old grease):