Download EIP-200S Ethernet/IP Adapter Distributed I/O

4BGeneral technical specifications
5.3 Use of subassemblies/modules in a Zone 2 hazardous area
Production location
Subassemblies/ modules
Test number
Article ID
Siemens AG,
Industry Sector
Werner-vonSiemens-Straße 50
92224 Amberg
ET 200S
KEMA 01
24037700
ET 200S fault-tolerant modules
ATEX 1238X
ZNX-EIP-200S
DEKRA 12ATEX0077 X
S7-300
KEMA 02
ET 200M
ATEX 1096X
24038475
DP/PA bus interface
Diagnostics repeater
S7-300 fault-tolerant modules
PROFIBUS Bus Connector Plug
KEMA 04
24028800
ATEX 1151X
Siemens AG,
Industry Sector
Őstliche
Rheinbrűckenstraβe 50
76187 Karlsruhe
Germany
S7-1200
KEMA 10
TS Adapter IE Basic
ATEX 0166X
S7-400
KEMA 03
46641616
21479867
ATEX 1125X
S7-300 CP
KEMA 03
TS Adapter II
ATEX 1128X
214976722
TS Adapter IE
ET 200M Marshalled Termination
Assemblies
KEMA 05
24193554
ATEX 1137X
Zone
Explosion hazard
Example
2
Explosive gas atmosphere occurs
only seldom and for a short time
Areas around flange joints with flat gaskets
in pipes in enclosed spaces
Safe area
No

Outside zone 2

Standard distributed I/O applications
Below you will find important information on the installation of the ET 200S distributed I/O
system in a hazardous area.
Note
Subassemblies/modules with ATEX II 3 G Ex nA II T3 .. T6 certification can only be used in
SIMATIC systems rated as category 3 equipment.
Maintenance
If repair is necessary, the affected module must be sent to the production location. Repairs
can only be carried out there.
EIP-200S Ethernet/IP Adapter Distributed I/O System
92
System Manual, 05/2012, A5E03822408-01