Download User Manual

infiniMap User Manual
Common User Interface Elements
Editing (Colour Correction)
The Editing options allow for simple, on the fly
colour correction that is applied to the
infiniMap image while rendering.
The settings are similar to the ones supplied
by LightWave 3D in the images panel.
Brightness
Changes the brightness of the image. At
100% the image is not changed, values below
that make it darker, values above 100%
brighten the image.
Contrast
This setting changes the contrast of the image. 100% is no change, anything below that lowers
the contrast, anything higher (yep, you guessed it) raises the contrast.
Hue
The Hue setting changes the Hue of the image, basically cycling the colours through the colour
spectrum. It is measured in degrees. 0° is the default. A setting of 360° degree is a full circle and
the same as 0°.
Saturation
This changes the saturation of the image. 100% is the default value, at 0% the image will be
greyscale only.
Gamma
This allows you to add gamma to your image.
To “degamma” (i.e. remove the gamma of an image) you can type in 1 / gamma – where
gamma is the gamma of the image you'd like to neutralize. (i.e. If your image has a baked in
gamma of 2.2, you can type in 1 / 2.2 which results in 0.4545 to remove the gamma and
linearize the image).
Invert
Invert inverts the colours of the image.
Default
This resets the values to their default settings. Enveloped values can unfortunately not be reset
due to SDK limitations.
26. September 2010 - Version 1.6
Page 14