Download User Manual - EngravePro

Transcript
Creating Custom Borders
When creating custom borders a few important points should be considered.
Draw your border at the proper aspect ratio. In other words, if your plate is going to be 1 inch tall
and 12 inches long, create your border at 1 inch tall and 12 long or a 1:12 ratio. If you make it 3
inches tall and 12 inches long, when you use it for your border it will distort, thus producing
undesired results.
If you are intending on using the border as a cutout, make sure you set the line width to .001 and
its color to red before saving the file.
By default CopyPro looks in the “\Program Files\TMSi\EngravePro\Borders “, Directory for
borders. However, you can load your borders from anywhere on your PC.
When saving your Border from CorelDRAW, select your border and export it with the “Selected
Only” option in the file save dialog box.
You must save your file as an Enhanced Windows Metafile (EMF).
If your border is an odd shape, it may be better to put it in your CorelDRAW layout instead of
importing it through Copy Pro. The reason is simply Copy Pro does not reposition your lines to
fit within a particular border. Although CopyPro does just fine with borders that are rectangular in
shape, odd shaped borders present unique layout issues. For example consider the two plates
below:
Test Plate
Second Line
Figure 1 with a rectangular border and imported works fine.
Figure 2 however does not work, especially because the aspect
ratio of the border does not match the plate. Here our example
Test Plate
is a 1 by 3 inch plate. The border was designed for a 1.5 by 3
Second Line
plate. The result is a border shortened thus running into your
text. The solution here would be to put your border into your layout while in CorelDRAW and
reposition your lines of text.
- 75 -