1
Download AMOS Command Files User`s Manual
Transcript
The IF Statement Page 4-5 4.4CHECKING FOR ERRORS The following reserved words are defined so you can check for specific errors and conditions reported by the monitor: STANDARD ERROR CODE 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 256 257 258 RESERVED WORD ERR’SPC ERR’MEM ERR’FNF ERR’FAX ERR’RDY ERR’FUL ERR’ERR ERR’USE ERR’ILC ERR’PRV ERR’WRT ERR’TYP ERR’DNX ERR’IBN ERR’INI ERR’FNO ERR’FAO ERR’KPT ERR’MNT ERR’IFL ERR’BBH ERR’BBW ERR’BBN ERR’NOQ ERR’MFD ERR’LNM ERR’RNR ERR’FIU ERR’RIU ERR’EMB ERR’DEL ERR’REN ERR’RNL ERR’RNO ERR’LQF ERR’NFS ERR’IRS ERR’BLK ERR’MSC ERR’MAP ERR’IPR Command File User’s Guide, Rev. 00 ERROR No error detected File specification error Insufficient free memory File not found File already exists Device not ready Device full Device error Device in use Illegal user code Protection violation Write protected File type mismatch Device does not exist Illegal block number Buffer not INITed File not open File already open Bitmap kaput Device not mounted Invalid filename BADBLK.SYS has a bad hash total BADBLK.SYS is in unsupported format BADBLK.SYS not found Insufficient queue blocks MFD is damaged First logical unit is not mounted Remote is not responding File in use Record in use Deadly embrace possible File cannot be deleted File cannot be renamed Record not locked Record not locked for output LOKSER queue is full Device is not file structured Illegal record size Block allocate/deallocate error Miscellaneous error Memory map destroyed Insufficient privileges to run program
