Download FX2N-64DNET DeviceNet Interface Block USER`S MANUAL

FX2N-64DNET DeviceNet Interface Block
Diagnostics 8
Table 8.5: 64DNET Error Code
Service Type
(Upper Byte)
Detailed error
code
(Lower Byte)
Description
Check Points
Get_Attribute_Single service error (An error with the read request of the Master)
04
03
An invalid value for the Instance
ID and the Attribute ID of the Get
service command was specified.
Check the packet data of the Get
service request from the Master
and correctly specify the Attribute
ID value.
Set_Attribute_Single error (An error with the write request of the Master)
02
The Set service is not supported
by the specified Attribute ID.
03
The Attribute ID is outside the
range.
04
The attribute value written in the
Set service is outside the range.
05
Do not use the Set service
request with the specified
Attribute ID.
Correctly specify the Attribute ID.
Reset service error (An error with the reset request of the Master)
06
01
The state of the connection is
contradicted.
Do not reset except when in
time-out.
02
The parameter of the Reset
service is outside the range.
Correctly specify parameter.
8-9