Download MPLAB IDE User`s Guide
Transcript
MPLAB® IDE User’s Guide 8.2 CHANGING WINDOW DATA AND PROPERTIES MPLAB IDE windows have some or all of the listed properties, depending on the type and use of the window. 8.2.1 Changing Window Data – Edit-in-Place or Choose from List MPLAB IDE window data may be edited as described below. If you cannot edit the data, then this information is not available for you to change. • Data may be edited “in place”, i.e., double-click to select an item and then type in a new value. • Date may be chosen from a drop-down list when only certain choices are possible. 8.2.2 Changing Window Location – Dock/Undock Docking • Windows may be made dockable (able to be attached to the top or sides of the MPLAB IDE desktop) by selecting “Dockable” from the window system menu (click in the upper left-hand corner). Note: File (editor) windows may not be made dockable. • Dockable windows may be docked by dragging them to the desired docking location. • Dockable windows may be floated, i.e., dragged off of the MPLAB IDE desktop. Undocking • Dockable windows may be undocked by double-clicking on the gripper bar. • Docked windows may be made undockable by right-clicking on the gripper bar and selecting “Dockable” from the menu. • Undocked windows may be made undockable by right-clicking on the title bar and selecting “Dockable” from the menu. 8.2.3 Changing Window Columns – Size, Visibility, Order • Columns can be resized as follows: move the cursor over the line between columns till it changes to the resize cursor and then click and drag to widen or narrow the column. • Columns can be made visible/invisible as follows: - Right-click on any column head and check an item from the list to make it visible. - Right-click on any column head and select More to open the window Properties dialog, Column Settings tab, (see Section 9.17 “Properties Dialog”) where you may set column visibility. - Right-click in the window and select Properties. On the Column Settings tab, you may set column visibility. • Columns can be ordered as follows: - Click on any column head and drag it to the desired location. - Right-click on any column head and select More to open the window Properties dialog, Column Settings tab, (see Section 9.17 “Properties Dialog”) where you may set column location. - Right-click in the window and select Properties. On the Column Settings tab, you may set column location. DS51519A-page 102 2005 Microchip Technology Inc.