Download Digital Standard: EUTRA / LTE

EUTRA/LTE
EUTRA/LTE Configuration and Settings
General DL Settings / General TDD DL Settings
Subframe Offset (Delta_CSI-RS) ← ZeroTxPower CSI-RS Structure
Sets the parameter subframe offset ΔCSI-RS for CSI-RS with zero transmission power, see
​table 7-8.
Remote command:
​[:​SOURce<hw>]:​BB:​EUTRa:​DL:​CSIS:​ZPDelta?​ on page 452
Cell-specific CSI-RS Structure
Comprises the following cell-specific parameters:
CSI-RS State ← Cell-specific CSI-RS Structure
Enables the transmission of a CSI-RS, see also ​"How to enable a CSI-RS transmission" on page 141.
Remote command:
​[:​SOURce<hw>]:​BB:​EUTRa:​DL:​CSIS:​STATe​ on page 452
Number of CSI-RS Antenna Ports ← Cell-specific CSI-RS Structure
Defines the number of antenna ports (one, two, four or eight) the CSI-RS are transmitted
on.
Use the ​Cell Specific Antenna Port Mapping and configure the cell-specific antenna port
mapping of the antenna ports AP15 - AP22.
Remote command:
​[:​SOURce<hw>]:​BB:​EUTRa:​DL:​CSIS:​NAP​ on page 451
CSI-RS Configuration ← Cell-specific CSI-RS Structure
Defines the CSI-RS configuration used for the current cell and for wich the UE assumes
non-zero transmission power. The zero transmission power sunframes are determined
by the ​ZeroPowerCSI-RS (HEX).
Remote command:
​[:​SOURce<hw>]:​BB:​EUTRa:​DL:​CSIS:​CONFig​ on page 451
Subframe Config (I_CSI-RS) ← Cell-specific CSI-RS Structure
Sets the parameter ICSI-RS for cell-specific CSI-RS, see ​table 7-8.
Remote command:
​[:​SOURce<hw>]:​BB:​EUTRa:​DL:​CSIS:​SFI​ on page 452
Periodicity (T_CSI-RS) ← Cell-specific CSI-RS Structure
Sets the parameter subframe configuration period TCSI-RS for cell-specific CSI-RS, see ​
table 7-8.
Remote command:
​[:​SOURce<hw>]:​BB:​EUTRa:​DL:​CSIS:​SFT?​ on page 452
Subframe Offset (Delta_CSI-RS) ← Cell-specific CSI-RS Structure
Sets the parameter subframe offset ΔCSI-RS for cell-specific CSI-RS, see ​table 7-8.
Remote command:
​[:​SOURce<hw>]:​BB:​EUTRa:​DL:​CSIS:​SFDelta?​ on page 451
User Manual 1175.6703.02 ─ 02
143