Download Hardware User Manual

Transcript
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Name
Vdd
GND
SADDR1)
NC (MCLK)
nReset
SCL
SDA
NC
GND
PCLK
FV
LV
NC
STROBE
D0
D1
D2
D3
VddIO
GND
D4
D5
D6
D7
GND
NC
NC
NC
NC
nOE
Type
PWR
PWR
IpU
I
I
I/O
PWR
O
O
O
O
O
O
O
O
PWR
PWR
O
O
O
O
PWR
IpU
Description
Voltage Supply
Power Ground
Not Connected (internally pulled up with 10kΩ)
Not connected (Camera Master Clock)2)
Reset (Active Low)
Configuration Bus Clock Line (external pull-up needed)
Configuration Bus Data Line (external pull-up needed)
Not connected
Power Ground
Pixel Clock
Line valid (VSYNC)
Frame valid (HSYNC)
Not connected
Strobe Signal
Pixel Data (LSB)
Pixel Data
Pixel Data
Pixel Data
I/O Voltage Supply
Power Ground
Pixel Data
Pixel Data
Pixel Data
Pixel Data (MSB)
Power Ground
Not connected
Not connected
Not connected
Not connected
Output Enable (Active Low; internally pulled up with 10kΩ)
Table 4-2: BLT-ISM-Connector interface description for Blackfin-based hardware (X2)
1)
The address of the sensors serial interface is 0xBA for write, and 0xBB for read access. The address the addresses
may be changed to 0x90 and 0x91 by connecting the SADDR pin to ground.
2)
The Master Clock is generated by the on board oscillator. If a different clock frequency is needed, there is a
possibility to apply an external clock signal to a modified Module. For modification details please contact
Bluetechnix.
ISM-MT9M131-Color_HUM_V2.0.docx
12