Download User manual TM63

TECO
TECO
MARITIME AS
Basic Operating Instructions
The following instructions are written to familiarize the user with the most common responses of the instrument.
These instructions will allow immediate operation of the instrument but should not be used in place of the
manufacturer’s instrument manual, rather as a convenient reference during the routine operation of the instrument.
Powering the Instrument
The instrument can be run from either a 120V or 240V mains supply. To ensure that the appropriate voltage has
been selected refer to the labelled fuse located on the back panel immediately below the mains socket. To alter
the voltage setting, refer to the instrument manual.
Instrument operation
Instruction
Instrument Response
Switch the instrument ON using
the ON/OFF rocker switch
on the back panel.
Instrument will follow a
self-test and auto calibration
routine.
Select method number by using the
UP and DOWN keys and press ENTER.
Displays method number
and default concentration unit.
Press CAL to zero instrument
Zero concentration display
Method number
Analysis of Test Samples
Ensure that the instrument has the appropriate cuvette or sample vial holder fitted within the sample chamber for
the test to be carried out. To fit the tray, remove existing tray by loosening the thumb screw located
underneath the sample chamber. Remove the tray and fit alternative tray, tighten thumb screw until secure.
Prepare any test sample in an appropriate manner and select the required test method using the information
described above. Transfer the reference sample into one of the matched pair of sample cells.
The following instructions now apply:
Instruction
Instrument Response
Insert the relevant reference sample
into the instrument. Press CAL
Zero concentration display
Method number
Insert cuvettes or sample tubes containing the prepared test solutions into the instrument to obtain the result as
concentration or appropriate unit of measure.
TECO Maritime AS
P.O.Box 462, N-1327 Lysaker, Norway. Tel: +47 67 200 380, Fax: +47 67 200 381, e-mail: [email protected] Web: http://www.teco.no/
Page 11 of 26