Download Xtender - JHRoerden

Steca
Xtender
No. of
config.
1261
1262
1263
1264
1265
1266
1286
1298
1300
1303
1304
1307
1309
1403
1404
1432
1433
1435
1436
1470
1485
1488
1505
1506
1510
1516
1517
1527
1528
1532
1547
1565
Denomination / description
Units
Auxiliary contact 1 activated by power 2
Power 2 above which auxiliary contact 1 is activated
Duration of power 2 for activating auxiliary contact 1
Auxiliary contact 1 activated by power 3
Power 3 above which will be activated auxiliary contact 1
Duration of power 3 for activation of auxiliary contact 1
Output voltage
Increment step of the adaptive low voltage method
Number of overloads permitted before definite stoppage
Number of battery over-voltages accepted before definite
stoppage
Number of battery under-voltages permitted before final
stop
Reset voltage for adaptive correction
Minimum ACin voltage to authorise charging
Period for counting battery over-voltages
Period for counting battery under-voltages
Maximum ACin voltage to switch to inverter mode
Adaptation range of the charge current according to the
input voltage
Method of fast detection
Allow to exceed AC input current without opening the
transfer relay
ACin voltage hysteresis for closing the transfer relay
Automatic earth-neutral connection in inverter mode
Critical under voltage of the battery
Delta of higher frequency accepted
Delta of lower frequency accepted
Tolerance of fast detection
Auxiliary contact 1 deactivated by floating mode
Auxiliary contact 2 deactivated by floating mode
Decrease max input limit current with AC-In voltage
Delay before closing transfer relay
Kind of dynamic compensation
y/n
%
min.
y/n
%
min.
Vac
mV/cell
---
Fact.
value2
yes
80
5
no
50
30
230 / 120
20
3
3
--
3
V/cell
Vac
sec.
sec.
Vac
V
2.2
185 / 142
60
0
270 / 135
20 / 10
y/n
y/n
no
yes
Vac
y/n
V/cell
Hz
Hz
-y/n
y/n
y/n
Min.
Auto/
Man
y/n
Sec.
10 / 5
no
1.5
35
15
4
yes
no
no
0
Auto
Allow slave stand-by in multi units system
Accoustic alarm duration
Mod.
value
yes
0
To modify the configurations, please refer to the operating instructions for the RCC-02/03
remote control
2
The second value concerns the 120Vac ranges
User manual
V.3.1.0
41