Download SP - Appliances Online

aus
Fault, what to do?
Spray arms
3 Fault, what to do?
Limescale
and contaminants in the rinsing water
may block nozzles
and bearings on the spray arms 1:
and 1B.
1. Check outlet nozzles on the spray
arms for blockages.
2. Unscrew the upper spray arms 1:
(1/4 revolution).
w
tha
ot
Experience has shown that you can
rectify most faults which occur in daily
operation yourself. This ensures that
the machine is quickly available to you
again. In the following overview you can
find possible causes of malfunctions
and helpful information for rectifying
them.
Note
If the appliance stops during
dishwashing or does not start for no
obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled “Operating
the appliance”)
3. Remove the lower spray arm 1B
upwards.
4. Clean spray arms under running
water.
5. Re-engage or screw on spray arms.
24
,tulF
a
m Warning – Don’t forget: Repairs may
be carried out by technicians only. If a
component has to be replaced, ensure
that only original spare parts are used.
Improper repairs or use of non-original
spare parts may cause considerable
damage and put the user at
considerable risk.
do?