Download E30A Emulator User`s Manual

E30A Emulator User’s Manual
3. Starting Up the Emulator Debugger
(3) Writer Mode
This function is valid when “Writer” is selected. This mode is used when using the E30A emulator as the flash ROM
writer. Select a load module file to be downloaded.
- Click “Add…” to open a dialog box to select a load module file. Multiple files can be selected.
- To cancel the selection, select the file and click “Remove…”.
If you want to enable the verification and checksum functions, select the check box.
You cannot debug the program in writer mode. Restart or terminate the emulator debugger after writing the program.
Notes on Writing the ID code:
The ID code is written into the flash memory only when the program was downloaded in writer mode.
When operating in other than the writer mode, no ID code is written into the flash memory even when
the program is downloaded. In that case, an ID code consisting entirely of FFh is assumed.
3.3 Resetting the User System
When using the coaxial connector or the coaxial converter board for connecting the E30A emulator and user system, by
clicking “OK” in the Init dialog box, the dialog box shown below will be displayed. When using the option board, the dialog is
not displayed because the target MCU is reset in hardware from the emulator.
- If the user system has already been powered on, reset the user system. If the power for the user system is turned off, turn the
power on.
- Click “OK”.
Notes on Power Supply to the User System:
The emulator does not supply power to the user system. Provide power to the user system separately.
Do not change the voltage of the user system after turning on the power.
R20UT0422EJ0500 Rev.5.00
Dec 01, 2010
Page 39 of 66