Download User manual User Guide - COMM-TEC

MultiCoder™ MC-TRANS V4.4.61
User Guide V1.2
Adapter:
HLS Streaming:
File Duration (sec):
Loop Duration (sec):
Specifies the IP-address of the used network card in which the
desired output stream will be sent. If several network ports are
used, the MC-TRANS lists all detected network port in this dropdown field.
Enables / Disables the HTTP streaming to an Apple device like
iPad. This check-box must be enabled, when you want to use the
‘HLS Streaming’-Link inside the ‘Encoder’ menu.
If you check the ‘HLS Steraming’ checkbox, the new menu point
‘HLS Streaming’ appears, where you can check the HLS stream.
See also chapter 3.4.3 on page 24. The requirements must be
satisfied to use this stream correctly.
Specifies the file duration of the HTTP streaming files.
Specifies the duration for a loop of HTTP streaming files. For
example: The file duration has 10 seconds and the loop duration
is set to 120 seconds, then the files will be streamed 12 times as a
loop.
Table 8: Description of the 'Encoder/Destination' webpage of the MC-TRANS
21