Download CE test report

Page 2 of 30
Report No. SEC-07-38
Test case verdicts
Test case does not apply to the test object.................. : N(.A.)
Test item does meet the requirement .......................... : P(ass)
Test item does not meet the requirement .................... : F(ail)
Testing
Date of receipt of test item ........................................... : 2007-08-13
Date(s) of performance of test………………………:
2007-08-20 to 2007-09-14
General remarks
This report is not valid as a CB Test Report unless signed by an approved CB Testing Laboratory and
appended to a CB Test Certificate issued by a NCB, in accordance with IECEE 02.
This report shall not be reproduced except in full without the written approval of the testing laboratory.
The test results presented in this report relate only to the item(s) tested.
"(see appended table)" refers to a table appended to the report.
“(see remark #)” refers to a remark appended to the report.
“(see Annex #) refers to an annex appended to the report.
Throughout this report a comma (point) is used as the decimal separator.
Summary of Testing and Conclusions
The sample(s) tested complies with the requirements of IEC 60065_2001
Additional information
1. The model name is WCS-222
2. All tests were performed on model WCS-222 to represent the other similar models.
3. Power supply cord set (except VDE certificate, see appended table 14) was not check in this report.
Compliance has to be checked at final installation.
TRF No: IEC60065D
TRF originator BEAB