Download G400 - User Manual
Transcript
2.5 EXT. KEY led EXT. KEY lights when a jack is plugged into the side chain insert on the rear of the G400. 2.6 THRESHOLD control THRESHOLD sets the reference level at which the gate will open and allow audio through to the output. Control range is -50dBu to +20dB. The side chain on the G400 has been designed with 'auto-level-sensing' and Hold circuitry to ensure that both fast transient and low frequency signals operate the gate without false triggering and/or chatter. However if the gate repeatedly opens and closes on a particular signal, reducing the THRESHOLD level can often correct this. 2.7 ABOVE-BELOW leds These two leds indicate the relationship between the side chain signal (which is normally the same as the input signal unless the side chain insert is used) and the THRESHOLD setting. The BELOW led indicates that the signal level is below threshold and the gate is closed. In practise, when the BELOW led lights the audio starts to fade at a rate set by the RELEASE control. The ABOVE led indicates that signal levels are above threshold and the gate is open. When the gates closes, the ABOVE led starts to fade at a rate set by the RELEASE setting. 2.8 ATTACK switch Two switchable ATTACK rates are available on the G400 SLOW provides an attack speed which is suitable for most program material without introducing transient clicks. FAST is intended for gating percussive instruments or signals with fast attacks transients. Page 6