Download User Manual

2.
3.
4.*
5.*
6.*
7.*
8.*
9.*
10.*
11.*
12.*
13.*
14.*
15.*
16.*
17.*
18.*
19.*
20.*
21.*
22.*
23.*
24.*
25.*
26.*
27.*
28.*
29.*
30.*
31.*
32.*
23.*
24.*
25.*
26.*
27.*
28.*
29.*
30.*
31.*
tA
tA
tA
tA
tA
tA
tA
tA
IA
IA
positive
negative
positive
negative
positive
negative
positive
negative
positive
negative
tA
positive
0.5In
tA
negative
0.5In
tA
positive
1In
tA
negative
1In
tA
positive
2In
tA
negative
2In
tA
positive
5In
tA
negative
5In
IA
positive
IA
negative
tA
positive
0.5In
tA
negative
0.5In
tA
positive
1In
tA
negative
1In
tA
positive
2In
tA
negative
2In
tA
positive
5In
tA
negative
5In
IA
positive
IA
negative
tA
positive
0.5In
tA
negative
0.5In
tA
positive
1In
tA
negative
1In
tA
positive
2In
tA
negative
2In
tA
positive
5In
tA
negative
5In
IA
positive
IA
negative
* points in which an efficient RCD should be disconnected
0.5In
0.5In
1In
1In
2In
2In
5In
5In
Notes:
- The number of measured parameters depends on the settings entered in the main menu.
- UB and RE are always measured.
- Automatic measurement is interrupted in the following cases:
 the switch was tripped during the measurement of UB RE or tA at the half value of IΔn,
 the switch did not trip during other component measurements,
 the value of safe voltage UL has been exceeded,
 voltage was disconnected during one of the component measurements,
18