Transcript
Battery Precautions: 1. Use only the size and type of batteries specified. 2. Always purchase the correct size and grade of battery most suitable for the intended use. 3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. 4. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries. 5. Replace all batteries of a set at the same time. Do not mix old and new batteries. 6. Clean the battery contacts and also those of the device prior to battery installation. 7. Do not dispose of batteries in fire. 8. Remove batteries if consumed or if product is to be left unused for an extended period of time. LED FLEX LIGHT 1 Location of Controls 1. Super Bright LED 2. Flexible Light Neck 3. ON/OFF Switch with Dimmer 4. Clip* 5. Battery Compartment* * Bottom of unit 2 WARNING: Modifications to this product not approved by the party responsible for compliance could void the user’s authority to operate the product. 3 ON/OFF/DIMMER Operation • Press once for full brightness. • Press again for softer light. • Press a third time to turn the light off. 4 5 Light Positioning and Hands-Free Use Light neck and light head separate from main body to point light right where you need it. Simply hold the base in one hand while unraveling the light head and neck apart to the desired lighting position. You can also adjust the light head and neck into any position while the base is sitting for hands-free use. To return the base. NOTE: To avoid damage to the unit, do not apply excessive force to bend the neck. Doing so will damage the unit and void the warranty. Inserting/Replacing the Batteries If the LED appears to be dim this is an indication that your batteries need to be replaced. To replace batteries: 1. Rotate clip out to expose the battery compartment cover. 2. Using a small phillips head screwdriver, remove the screw on the back of the light. As the screw is very small, take care as to not lose it after removing. 3. Remove battery compartment cover. 4. Remove old battery. 5. Replace with 1 new AAA battery. 6. Make sure to follow battery polarity guide when installing new battery. 7. Replace battery compartment cover. 8. Replace screw making sure not to overtighten. LPL664 Manual.indd 2-3 10/12/10 5:19:52 PM
