Download 1 - Jeep

Transcript
REVERSE
Use this range only after the vehicle has come
to a complete stop.
NEUTRAL
Shift into NEUTRAL when the vehicle is standing for prolonged periods with the engine running. The engine may be started in this range.
Set the parking brake if you must leave the
vehicle.
NOTE:
Towing the vehicle, coasting, or driving for
any other reason with the shift lever in
NEUTRAL can result in severe transmission
damage. Refer to “Recreational Towing” in
“Starting and Operating” and “Towing a Disabled Vehicle” in “What To Do In Emergencies” for further information.
DRIVE
The transmission automatically upshifts
through fifth gear. The DRIVE position provides
optimum driving characteristics under all normal operating conditions.
192
Electronic Range Select (ERS) Operation
The Electronic Range Select (ERS) shift control
allows you to move the shift lever left (-) or right
(+) when the shift lever is in the DRIVE position,
allowing the selection of the desired top gear.
For example, if the driver shifts the transmission
into third gear, the transmission will never shift
above third gear, but can shift down to second
gear or first gear, when needed.
WARNING!
Do not downshift for additional engine braking
on a slippery surface. The drive wheels could
lose their grip and the vehicle could skid.
Screen Display
Actual Gear(s)
Allowed
1
1
2
1-2
3
1-3
4
1-4
D
1-5
NOTE:
To select the proper gear position for maximum deceleration (engine braking), move
the shift lever to the left “D (-)” and hold it
there. The transmission will shift to the
range from which the vehicle can best be
slowed down.
Overdrive Operation
The overdrive automatic transmission contains
an electronically controlled fifth gear (OVERDRIVE). The transmission will automatically
shift from fourth gear to OVERDRIVE if the
following conditions are present:
• the shift lever is in DRIVE
• the engine coolant has reached normal operating temperature
• the vehicle speed is above approximately
30 mph (48 km/h)
• the transmission has reached normal operating temperature