Download * HP 3000 Systems

GOMPLITER SYSTEMS NEWSLETTER
Please be sure that the customer understands this limitation when ordering a printer for a 2640B. (Also see article
by Tom Lee in the DTD section of this Newsletter.)
I
New Options for 2630 Family
By: Larry AndrewsIBoise
8th Bit Alternate Character Set Selection
The 2631A can now be ordered witn Cyrillic or math symbols
as alternate character sets. Cvrillic is Option 007, and
HP 2640-Series compatible math symbols is Option 010.
U.S. list price is $150 for each option.
B y Larry AndrewslBoise
As you know, secondary character sets on the 2631 can
be selected by a shift-out character or the 8th data bit. Some
interfaces, however, don't pass the 8th bit to the printer.
The following 2631 interfaces support 8th bit protocol:
Also a paper catcher can now be ordered as option 002 to
the 26097A and 26098A pedestals. U.S. list price is
$50'00
New 263112635 Data Sheets
I
The following 2631 interfaces do not support 8th bit
protocol:
By: Steve DavisIBoise
e
Updated versions of the 2631A Data Sheet (Part No.
5952-9424 REV. 1-78) and the 2635A Data Sheet (Part
No. 5952-89425 REV. 1-78) are now available
STD
-040
-042
-044
-210
-240
-300
-
i
i
I
The new data sheets contain updated specifications for print
head and ribbon life. Also the System Configuration charts
have been revised to delete the serial interface to 264X
CRT's. Finally, the duty cycle section has been reworded
to more accurately define the print loads that the 2631A
and 2635A can handle.
HP 1000 line printer interface
RS232C without modem control
Current loop
HP 2640-Series CRT interface (8-Bit TTL)
HP 1000 line printer subsystem interface
HP 2640-Series CRT interface (&bit TTL)
HP 3000 line printer interface
13190B Obsolescence
The new data sheets can now be ordered from Corporate
L~teratureD~str~but~on.
By: Mike HarriganIBoise
The 13190B multi-unit cable is obsolete as of March 1, 1978.
This is a 20-foot long cable for daisy chaining an add-on
HP 7970B mag tape drive to an existing HP 7970B mag
tape drive. The 13194A is exactly the same cable, with
the exception that it will work on both the HP 7970B and
the HP 7970E mag tape drives. Therefore, if you have need
for a 20 foot multi-unit (daisy chain) cable for any HP digital
mag tape drive, you will now order the 13194A.
2631's and 2640's
By: Larry AndrewsIBoise
Remember when selling a 2631 to be used with a 2640A or
B that only the CRT's display memory can be dumped to
the printer (80 columns only). A 2645 with device control
firmware is required when data must go from the CPU
directly to the printer.
Volume 3, Number 8, March 1, 1978
-041 RS232C with modem control
-046 HP-IB
-051 RS232C with modem control and 2630-type edge
connector
Please contact Mike Harrigan at Boise Division if you have
any further questions.
3
FOR UNUERhJAL USE ONILV