Download AUTOMATIC TRANSMISSION SECTION AT

Transcript
DTC P0705 PARK/NEUTRAL POSITION (PNP) SWITCH
Component Inspection
Component Inspection
NGAT0030
PNP SWITCH
1.
NGAT0030S02
Check continuity between terminals 1 and 2 and between terminals 3 and (4, 5, 6, 7, 8, 9) while moving manual shaft
through each position.
Lever position
P
R
1-2
Terminal No.
N
2
1
3-7
3-8
3-9
1-2
3-5
3-4
D
3-6
SAT517GB
AAT482A
2.
3.
If NG, check again with manual control linkage disconnected
from manual shaft of A/T assembly. Refer to step 1.
If OK on step 2, adjust manual control linkage. Refer to AT-260.
AAT551A
4.
5.
6.
If NG on step 2, remove PNP switch from A/T and check continuity of PNP switch terminals. Refer to step 1.
If OK on step 4, adjust PNP switch. Refer to AT-260.
If NG on step 4, replace PNP switch.
AAT481A
AT-104