Download C300 HD Installation Guide
Transcript
Section 5 Installation Wiring Talkback and Oscillator Talkback Connections The C300HD console contains a built-in talkback microphone and amplifier. In addition, a second input is available for connection to an external dynamic microphone. This input is mixed with the internal T/B mic and the combined signal is available via an XLR connector on the audio interface panel beneath the console. This output signal should be connected to an analogue input circuit in the Centuri processor. The circuit chosen can then be assigned as the talkback source via the console’s routing. The gain of each mic signal can be independently adjusted. Access to the trim controls is from beneath the console on the console interface panel. The external mic input is via a 3-pin XLR female labelled ‘Ext T/B Mic In’. The mixed T/B output is via a 3-pin XLR Male labelled ‘Talkback Output’. Oscillator Connections The C300HD includes an inbuilt software oscillator capable of generating a range of sinusoidal frequencies as well as pink noise. This signal can be assigned to any relevant output without additional cabling. Alternatively, an external oscillator (either analogue or digital, mono or stereo) may be used. In this instance one or two circuits should be allocated on an input card, they can then be assigned as the oscillator source. Refer to Appendix C for connector pinouts. Page 41