1
Download Manual - Webstaurant Store
Transcript
Normal operation – Stage 4 One second (1 s) after the fan comes on, the COMPRESSOR output comes on. The compressor circuit uses both run and start capacitors along with a potential start relay. The start capacitor in energized through the normally closed contacts of the start relay. T.O.L. 2 Start High Pressure Switch Fan 1 Dis Start Relay se N L1 Fill Valve N P15 BLACK L1 YELLOW POWER LOW BIN MAKING ICE SLEEP CYCLE TIME DELAY RED BLACK R HI PRS 2 3 COMPRESSOR ut Drain Valve Inp Compressor Electrical Box WHITE 4 pen WHITE 5 Start Relay Ice Compressor RED Run R S C 12345678 P6 S C RESET P20 BROWN P19 BLACK WATER LEVELS P22 BLUE AUGER SERVICE HI AMPS P3 Gearmotor LOW WATER MAINTENANCE P21 BIN P4 HI PRESSURE DRAIN CLOG P11 CLEANER FULL A B C D Clean Switch Bin T-Stat Drain Clog Sensor Water Sensors Normal operation – Stage 5 As the compressor comes up to normal running speed, its start winding generates a voltage potential across the relay’s coil. This energizes the coil to open the contact and drop out the start capacitor. The ice machine is now in a normal ice making mode. The ice machine will produce ice until the bin level control in the ice dispenser is satisfied. T.O.L. Fan 1 N L1 Fill Valve N POWER LOW BIN MAKING ICE SLEEP CYCLE TIME DELAY RED BLACK R HI PRS 2 YELLOW P15 BLACK L1 3 COMPRESSOR ut 4 Drain Valve Compressor Electrical Box Inp Start Relay se WHITE 5 WHITE pen Dis Start Relay Ice RED 2 High Pressure Switch Start C Compressor Run R S 12345678 P6 S BROWN C BLACK RESET P20 P19 BLUE WATER LEVELS P22 AUGER SERVICE HI AMPS P3 Gearmotor LOW WATER MAINTENANCE P21 P4 BIN HI PRESSURE P11 DRAIN CLOG CLEANER FULL A B C D Water Sensors 22 Drain Clog Sensor Bin T-Stat Clean Switch 25CI425A/W, 25HI425A, 50CI425A/W, 50HI425A
