Download 13.5.2 Key Points Supporting Troubleshooting

white interfaces. Criterion for pass: bright point number is 0; number of
continuous dark point pair is ≤3, and no continuous dark point appears in the
image area; there are no three or more than three continuous dark point;
dark point defects number is ≤7, and number of dark points in the image area
is ≤2; point flash defects is 0; space between fail points is ≥5mm.
4. Click [Exit] or press [ESC] to return to the main screen interface.
7.1.4
NOTE:
Monitor Parameter Setting
After changing the main monitor, parameter loading should be performed to match the
monitor and the system.
The parameters of the main monitor include color temp, brightness/contrast, Gamma, and
Default, information of loading Default parameters are introduced here:
1. Press <1> and <4> key on the monitor as shown in the figure for more than 3 seconds to enter
the screen.
2. Press <1> or <2> to select Default, the cursor is on the Default position, press <4> to enter the
parameter automated loading, and it takes about 3 seconds to finish.
3. Color temperature is default to be 11000K, and adjustment is not recommended.
4. After all settings are finished, move the cursor to Exit or press <3> to exit the menu.
7.2
Touch Screen Adjustment
7.2.1
Touch Screen Brightness and Contrast Adjustment
NOTE:
Avoid operating under direct sunlight, or the touch screen could be blocked. Do not place
anything on the touch screen, or the screen view will be blocked.
Open the screen through the path: [Preset]->[Maintenance]->[Other], and click touch screen
brightness/contrast menu to perform the adjustment.
7-4 Adjustments