1
Download Instruction Manual
Transcript
7) Remove the filler cap, filler screws, and spring cartridge. See Fig. 12. Leave the thrust‑washers in place on the spring cartridge. NOTICE! Spring cartridge may be difficult to remove. Be careful not to damage the finish. Screws Filler Cap Thrust-Washers Filler Screws Fig. 12 Spring Cartridge Door 8) Clear material from the spring cartridge hole to allow for spring cartridge installation. Reinstall the filler cap, filler screws, and spring cartridge on the opposite side of the door. See Fig. 13. Screws Spring Cartridge Fig. 13 Spring Cartridge Hole Filler Screws Filler Cap Door 9) Make sure the thrust-washers are in place on the spring cartridge, then install the upper hinge bracket onto the spring cartridge. See Fig. 14. The upper hinge bracket should be canted out towards the center as shown with the screw holes towards the back of the appliance. 10) Remove the filler cap and nylon bearing from the bottom of the door. See Fig. 15. Reinstall on the opposite side. Screw Washer Screw Holes Upper Hinge Bracket Thrust-Washers Door Filler Cap Fig. 14 15 Fig. 15 Nylon Bearing
