Download 599735A - Dishwasher

599735A
4
OPTION ADJUSTMENT MODE
To enter this setup mode, press POWER, then hold the ECO touch switch and KEYLOCK button
simultaneously for 5 seconds, ensuring that ECO is pushed first. Once the setup mode is entered,
a beep is emitted and the LCD displays the letters rA. Pushing the START/PAUSE button allows
the user to scroll through and change the following options:• Rinse Aid Setup (rA).
• Water Supply Hardness Setup (hd) – only available on water softener models.
• Auto Power Option (AP).
• End of Cycle Beeps (EC).
• Closed Drawer Option (Ld).
• Clean/Dirty Dish Symbol (dS).
Note: there is no dry enhancement mode for DD60 / DD24.
Integrated:- On an Integrated DishDrawer™, where there is no display, the user can still tell
which option they have chosen by using the lights showing on the integrated badge as follows:• Rinse Aid Setup (red LED above Start/Pause button).
• Water Supply Hardness (green LED above Start/Pause button) – only available on water
softener models.
• Auto Power Option (orange LED above Start/Pause button).
• End of Cycle Beeps (green LED above Start/Pause button and ECO LED is red).
• Closed Drawer Option (red LED above Start/Pause button and ECO LED is red).
• Clean/Dirty Dish Symbol (no lLEDs above buttons, ECO LED is red).
Note: there is no dry enhancement mode for DD60 / DD24.
Push POWER at any time to exit this setup mode.
4.1
Rinse Aid Setup (rA)
The current rinse aid setting is shown using the red LEDs on the touch switch panel.
The amount of rinse aid dispensed into a rinse cycle can be varied to suit the level of hardness of
the local water supply. It can be set to 1 - 5 dispensing levels.
(1 = approx 0.5mls (1/10 teaspoon) of rinse aid, 5 = approximately 2.5mls (½ teaspoon) of rinse aid.
Push KEYLOCK to advance to the rinse aid setting. Once the desired setting is achieved, push
POWER to exit. The rinse aid index is stored in EE memory, so even with the power removed the
rinse aid level is retained.
4.2
Water Supply Hardness Setup (hd)
The current supply hardness setting is shown using the red LEDs on the touch switch panel. One
of five settings should be selected according to the known hardness of the supply water.
DishDrawer Setting
No LED
1 LED
2 LED
3 LED
4 LED
5 LED
Grains per Gallon (gpg)
0-6
6-14
14-20
20-26
26-32
32-36
Parts per Million (ppm)
0-100
100-250
250-350
350-450
450-550
550-625
Note: No LED = Water Softener turned off, continuous bypass of softener
Push KEYLOCK to advance to the water softener setting. Once the desired setting has been
achieved, push POWER to exit.
21