Download Disassembly and - Cutting Edge Machinery

Rubber Track Loader
9. Loader/Transmission Controls Disassembly and Assembly
Joystick Installation
Note: Since the procedures for installing both joystick controls are identical, only the right control joystick procedure
is described below.
Figure 9-4
Hose and
Control
Labels
9-004
7. Pull the joystick out of the console. The mounting plate, wiring harness and hoses will stay
connected to the joystick.
Figure 9-7
9-006
1. Match the factory labels on the hoses and the
control.
Disconnect
the Wiring
Harness
2. Connect the hoses.
Figure 9-5
9-005
Connect the
Wiring
Harness
8. Disconnect the joystick wiring harness.
Figure 9-8
Hose and
Control
Labels
Figure 9-6
3. Connect the joystick wiring harness.
9-006
9. The hoses and the control are labeled at the
factory. Make sure the labels are still legible.
10. Remove the hoses.
9-3
9-005