Download CF-74GCDADBM
Transcript
1. Disconnect the LCD/INV. Cable from the Connector on the Inverter. 2. Remove the LCD Unit. 3. Remove the Inverter with the Inverter Case. 4. Remove the two Screws <N18>, and then the W-LAN PCB L and R. 1. Remove the Palm Rest Sheet. 2. Remove the four Screws <N20>, and then PAD Base Ass'y. 3. Disconnect the two Cables from the two Connectors (CN1301, CN1302). 4. Remove the three Screws <N14>. 5. Remove the PAD Button WP Rubber and PAD SW PCB. 6. Remove the Touch PAD. Screws <N18>: XQN17+BJ6FJ 9.1.19. Removing the Touch PAD and PAD PCB Screws <N14>: DRHM0106ZA Screws <N20>: DXQT2+G4FCL 9.1.20. Removing the Finger PCB Palm Rest Sheet Finger PCB <N9> <N9> Pad WP Sheet A <N9> <N20> <N20> <N20><N20> PAD Base Ass’y PAD Button WP Rubber Touch PAD PAD SW PCB FP FFC Cable CN1302 <N14> <N14> CN1301 <N14> Finger Sensor Base Preparation Perform the steps up to removing of the Main PCB. 1. Remove the three Screws. <N9> 2. Remove the Finger PCB and Finger Sensor Base. Sheet Screws <N9>: DFHE5025XA 9-7