Download CHAPTER INDEX

BRAKE
Master Cylinder Removal
●Remove the master cylinder joint [A] and the banjo bolt [B]
at the brake hose lower end, and tighten it loosely.
●Remove the brake hose [C].
●Loose the master cylinder mounting bolts [D].
CAUTION
Brake fluid quickly ruins painted surface; any spilled
fluid should be completely washed away immediately.
●Remove:
Fastener [A]
Hose [B]
Reservoir [C]
Master Cylinder Installation
●Use a new flat washer on each side of the brake hose
fitting, and tighten the banjo bolt.
Torque -Brake Hose Banjo Bolt: 25N-m(2.5kg-m,18.0ft-lb)
●Check the fluid level [A] in the brake reservoir.
●Bleed the brake line after master cylinder installation (see
Brake Line Air Bleeding).
●Check the brake for good braking power, no braking brag,
and no fluid leakage.
△WARNING
Do not attempt to drive the vehicle until a full brake level
is obtained by pumping the brake level until the pads are
against each dis. The brakes will not function on the first
application of the level if this is not done.
【3-13】