Download Exploded View

OIL PAN (UPPER)
< UNIT DISASSEMBLY AND ASSEMBLY >
5. Loosen mounting bolts in the reverse order as shown in the figure with power tool to remove.
[VQ35HR]
: Engine front
• Insert the seal cutter [SST: KV10111100 (J-37228)] between
oil pan (upper) and lower cylinder block. Slide seal cutter by
tapping on the side of tool with a hammer. Remove oil pan
(upper).
CAUTION:
• Be careful not to damage the mating surfaces.
• Never insert a screwdriver, this will damage the mating
surfaces.
6.
JPBIA0022ZZ
Remove O-rings (2) from bottom of lower cylinder block (1) and
oil pump (3).
: Engine front
JPBIA1330ZZ
7.
Remove axle pipe, if necessary.
• Remove axle pipe from oil pan (upper) using a suitable drift (A)
[outer diameter: 37 mm (1.46 in)].
JPBIA0028ZZ
INSTALLATION
1.
Install axle pipe (3) to oil pan (upper), if removed.
• Lubricate O-ring groove of axle pipe, O-rings (1), (2), and Oring joint of oil pan with new engine oil.
Unit: mm (in)
Items
O-ring inner diameter
Final drive side (right side)
31.4 (1.236)
Axle pipe flange side (left side)
33.6 (1.323)
JPBIA0452ZZ
Revision: 2009 March
EM-104
2009 FX35/FX50