Download akpp/31TH 2000

NS
TRANSAXLE AND POWER TRANSFER UNIT
21 - 61
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 145 Checking Bearing Turning Torque
1 – OUTPUT SHAFT GEAR
2 – TORQUE WRENCH
Fig. 146 Turn Stirrup Clockwise Against Flats Of
Retaining Nut
1 – TURN STIRRUP CLOCKWISE
2 – STRAP
STIRRUP AND RETAINING STRAP
INSTALLATION
Once bearing turning torque and shim selection
has been adjusted, install stirrup and strap assembly
onto output gear.
NOTE: Once the stirrup assembly is positioned
onto the output gear, it is necessary to “clock” the
stirrup against the flats of the output gear retaining
nut.
(1) Position the stirrup on the output gear.
(2) Position strap.
(3) Install retaining bolts into output gear. Finger–
tighten bolts.
(4) Turn stirrup clockwise against the flats of the
output gear retaining nut (Fig. 146).
(5) Tighten retaining bolts to 23 N·m (200 in. lbs.)
(Fig. 147).
(6) Bend tabs of strap up against “flats”of retaining bolts.
Fig. 147 Tighten Strap Retaining Nuts
1 – STRAP
2 – OUTPUT GEAR
3 – STIRRUP