Download M30 - Amazon Web Services

Maintenance & Repair
M30 SERVICE INFORMATION
3. Remove the clevis pin and squeegee retainer.
LEVELING THE REAR SQUEEGEE
Leveling the squeegee assures the entire length of
the squeegee blade is in even contact with the
surface being scrubbed. Perform this adjustment on
an even and level floor.
1. Lower the squeegee and drive the machine
forward a few meters (feet).
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, set parking brake,
and turn off machine.
2. Look at the deflection of the squeegee over the
full length of the squeegee blade.
3. If the deflection is not the same over the full
length of the blade, turn the squeegee levelling
nut to make adjustments.
4. Pull the squeegee out from the side brush
assembly.
M
DO NOT disconnect the suction hose from the
squeegee frame when leveling squeegee.
5. Slide the new squeegee into the side brush
assembly.
6. Reinstall the squeegee retainer and clevis pin.
7. Close the squeegee bumper and reinsert the pin.
4. Turn the squeegee leveling nut counter-clockwise to decrease the deflection at the ends
of the squeegee blade.
Turn the squeegee leveling nut clockwise to
increase the deflection at the ends of the
squeegee blade.
5. Drive the machine forward with the squeegee
down to recheck the squeegee blade deflection if
adjustments were made.
6. Readjust the squeegee blade deflection if
necessary.
M30 9003947 (6--08)
36
Home
Find... Go To..