Download MAINTENANCE INTERVALS - Safety

Transcript
98
Maintenance Section
Maintenance Interval Schedule
SEBU7808-11
Initial 500 Service Hours
Every 12 000 Service Hours or 6 Years
Cooling System Coolant Sample (Level 2) Obtain ................................................................ 118
Loader Boom Pin Oil Level - Check .................... 153
Seat Side Rails - Adjust ...................................... 158
Cooling System Coolant (ELC) - Change ............ 114
Cooling System Water Temperature Regulator Replace .............................................................. 119
Every 500 Service Hours or 3 Months
Cooling System Coolant Sample (Level 1) Obtain ................................................................ 117
Differential and Final Drive Oil Sample - Obtain .. 123
Engine Oil (High Speed) and Oil Filter - Change .. 129
Engine Oil and Filter - Change ........................... 132
Fuel System Primary Filter (Water Separator)
Element - Replace ............................................ 138
Fuel System Secondary Filter - Replace ............ 139
Fuel Tank Cap and Strainer - Clean ................... 140
Hydraulic System Oil Filter (Steering and Implement
Pilot) - Replace ................................................. 147
Hydraulic System Oil Sample - Obtain ............... 149
Transmission Oil Filter - Replace ........................ 162
Transmission Oil Sample - Obtain ...................... 164
Every 1000 Service Hours or 6 Months
Articulation Bearings - Lubricate ........................... 99
Battery Hold-Down - Tighten ............................... 105
Case Drain Oil Filters - Replace .......................... 113
Drive Shaft Support Bearing - Lubricate ............. 124
Rollover Protective Structure (ROPS) - Inspect .. 157
Transmission Oil - Change ................................. 160
Every 2000 Service Hours or 1 Year
Axle Oil Cooler Filter - Replace .......................... 103
Cooling System Coolant Sample (Level 2) Obtain ................................................................ 118
Crankshaft Vibration Damper - Inspect ............... 120
Differential and Final Drive Oil - Change ............ 120
Electronic Unit Injector - Inspect/Adjust .............. 124
Engine Mounts - Inspect ..................................... 129
Engine Valve Lash - Check ................................. 135
Engine Valve Rotators - Inspect ......................... 135
Hydraulic System Oil - Change ........................... 144
Hydraulic Tank Breaker Relief Valve - Clean ...... 149
Lift Cylinder Pin Oil Level - Check ...................... 151
Loader Boom Pin Oil - Change ........................... 152
Refrigerant Receiver-Dryer - Replace ................ 156
Every 3 Years After Date of Installation or
Every 5 Years After Date of Manufacture
Seat Belt - Replace ............................................. 158
Every 4000 Service Hours or 2 Years
Hydraulic System Oil - Change ........................... 144
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add ... 115
Lift Cylinder Pin Oil - Change ............................. 149