Download RAS-M18UAV-E

12-3. Outdoor Unit
No.
Part name
a
Common
procedure
Procedure
Remarks
1. Detachment
Upper cabinet
NOTE
Wear gloves for this job.
Otherwise, you may injure your
hands on the parts, etc.
1) Stop operation of the air conditioner,
and turn off the main switch of the
breaker for air conditioner.
2) Remove the valve cover.
(ST1TØ4 × 8L 3 pcs.)
• After removing screw, remove the
valve cover pulling it downward.
3) Remove the upper cabinet.
(ST1TØ4 × 8L 5 pcs.)
• After removing screws, remove the
upper cabinet pulling it upward.
2. Attachment
1) Attach the water-proof cover.
NOTE
Water proof cover
Valve cover
Insert the bent part
into the rear panel
of the inverter
Bring into contact
against these parts
The water-proof cover must be
attached without fail in order
to prevent rain water, etc. from
entering inside the indoor unit.
2) Attach the upper cabinet.
(ST1TØ4 × 8L 5 pcs.)
3) Perform cabling of connecting cable.
4) Attach the valve cover.
(ST1TØ4 × 8L 3 pcs.)
• Insert the upper part into the
square hole of the side cabinet, set
hook claws of the valve cover to
square holes (at three positions) of
the main unit, and attach it pushing
upward.
– 100 –
Align the stitch line
with the top edge
of the front cabinet
Bend downward, and align
with the inside surface
of the front cabinet
How to mount the water-proof cover