Download sta 315 operation manual

MACHINE : CIRCULAR SAW
TYPE:
STA 315
OPERATION MANUAL
During cutting, in order to prevent the damage of one edge of the piece only, you may use every kind
of scorring circular disk.
In that case the main disk should be leveled with one side of the scorring circular disk only.
D.1.5. Operation of the circular saw
The circular saw can perform the following operations:
- Longitudinal cutting of pieces of massive wood;
- Transversal cutting of pieces of
massive wood;
- Cutting of planes.
Longitudinal cutting of pieces of massive wood
In order to carry out this operation
you must use the following safety devices:
- parallel ruler A;
- protection cover В of the circular
disk G;
- splitting cutter С;
- insert Е in the board;
The adjustment of the parallel ruler A
towards the cutting disk is measured by
the scale F.
А
C
B
E
F
G
I
K
fig. 19
Transversal cutting of pieces of massive wood
In order to carry out this operation you must use the following safety devices:
- mobile frame J;
- transversal support ruler I with support for the piece;
- protection cover В of the circular disk G;
- splitting cutter С;
- miter gauge К;
- insert Е in the board;
Cutting of planes
In order to carry out this operation you must use the following safety devices:
- mobile frame J;
- transversal support ruler I with support for the piece;
- protection cover В of the circular disk G;
- splitting cutter С;
- miter gauge К;
- insert Е in the board;
i
fig. 20
INFORMATION
For cutting of laminated plates it is required to make use of the scorring circular disk in order to
avoid the damage on the edges during cutting with the main disk.
The undercutting disk must be adjusted in height so that the depth of section is 1-1.5 mm (fig. 20).
Page 21