Download INSTALLATION INSTRUCTIONS

[4] HEAD ASSEMBLY INSTALLATION (FIGURE 21):
Arm Holding Band
1. Remove a screw (a) on arm collar, and place the arm
collar over the stopper ringon the head shaft.
(Direction of arm collar is shown in FIGURE 21.)
Balance Arm
2. Remove the yoke inside cover by loosening
screw(b).
3. Making sure the stopper ring and arm collar is
placed on the head shaft, insert the wirings of balance arm through the head shaft to the head yoke.
Balance Arm
Wiring
Head Key
Arm Collar
4. Insert the head shaft into balance arm assembly, and
while holding the head in position, install head key
securely into retaining groove.
5. Slide the arm collar upward to proper position and
secure it in place with a screw (a).
1mm
mm
(a)
Head Shaft
Stopper Ring
Head Yoke
(b)
Terminal
6. Loosen 5 screws on the terminal using a small dia.
screw driver, and insert the wirings of balance arm
assembly into the terminal according to the color.
(FIGURE 22)
Yoke Inside
Cover
7. Retighten the screws on the terminal and confirm
that the wirings are fixed on the terminal.
FIGURE 21
8. Remove M5 Phillips head screw from earth terminal
and secure No.8 wiring together to earth terminal.
9. Reattach the yoke inside cover with a screw.
10. Remove arm holding band.
Small Diameter
Screw Driver
W
irin
Ar gs o
m
f
As Bal
se an
mb ce
ly
6
3
4
5
6
7
8
Blue
Brown
Red
Yellow
Gray
Green/Yellow
Earth Terminal
FIGURE 22
– 16 –
From 2004 July