Download 6. CVS-841C/841P - SI-TEX Marine Electronics

CVS-841/851
Chapter 4
Installation
4.7.3.2 Connecting the TD cable
(1) In the case that CVS-841/851 are the specification of standard 2 frequencies
Example 1. [Single Frequency TD except TD-2001D]
The display unit and the transducer cables are connected on 1:1 basis, as follows. Solder the cables
and apply winds of PVC tape to make sure of good isolation between the cables.
To J7/Display rear panel
CW-836-3M
Red
Black
Green
White
Single
TDFrequency
(High Freq)
TD
(High Freq)
Black
Black
White
White
Single
TDFrequency
(Low Freq)
TD
(Low Freq)
Shield
Shield
Example 2. [Single Frequency TD, TD-2001D]
The display unit and the transducer cables are connected as follows:
Red
Red
White
To J7/Display rear panel
Green
Green
Black
CW-836-3M
Black
Black
White
White
Single Frequency
TD
TD
(High Freq)
(High Freq)
TD-2001D
TD-2001D
Single Frequency
TD
(Low Freq)
TD
(Low Freq)
Shield
0093132682-08
Shield
4-9