Download Monarch RT3/R

Transcript
9
Reinstall the shock mounting hardware (see the Mounting
Hardware And Bushing Service section).
10
Reinstall the shock to your bicycle frame according to the bicycle
manufacturer's instructions.
11
Use a shock pump to pressurize the shock to the desired air
pressure, then install the valve cap.
High Volume and DebonAir TM Air Can: Align decal orientation
before pressurizing.
12
DebonAir TM Air Can only: Use a shock pump to pressurize the shock to the desired air pressure. After adding air to the shock, the
pressure will need to be equalized between the shock chambers.
Record the air pressure value on the pump, then unthread it from the shock. Slowly but firmly press or sit on the saddle to
compress the shock until there is a hissing sound.
This sound indicates air transfer between chambers. Record the air pressure, then unthread it from the shock. Repeat this process
until you reach the desired amount of sag.
NOTIC E
When pressurizing the shock, do not exceed 275 psi.
The pump must be removed from the shock prior to checking sag to avoid damage to the pump.
This concludes the service for the Monarch™ RT3/R rear shock.