Download MAINTENANCE INTERVALS - Safety

168
Maintenance Section
Drive Shaft Support Bearing Lubricant - Check
i00687064
Drive Shaft Support Bearing
Lubricant - Check
(If Equipped)
SMCS Code: 3267-535
Illustration 316
g00102923
3. Loosen the hose clamp. Remove the hose from
the elbow.
4. Remove the bolts from the elbow. Remove the
elbow. Remove the gasket.
5. Remove the water temperature regulator from the
water temperature regulator housing.
Note: Inspect the gasket before assembly. If wear
or damage is found, replace the gasket.
Illustration 317
g00102456
The drive shaft support bearings are located below
the center of the machine.
1. Remove the plug.
6. Install a new water temperature regulator. Install
the gasket. Install the elbow. Install the bolts in
the elbow.
2. Check the lubricant level. The bearings should
be covered with lubricant.
7. Connect the hose to the elbow. Tighten the hose
clamps.
Note: Refer to Operation and Maintenance Manual,
“General Hazard Information” for information in
Containing Fluid Spillage.
8. Restore the coolant level to the correct operating
level. Refer to the Operation and Maintenance
Manual, “Cooling System Level - Check” for
details.
9. Close and secure access cover (2). Close and
secure access door (1).
3. If necessary, add lubricant.
i00995144
Drive Shaft Universal Joint Lubricate
SMCS Code: 3251-086; 3253-086
Illustration 318
g00102443