Download TP-6772

2.6 Advanced Digital Control IId
Operation
The pushbutton/rotary selector dial has several features
and functions:
D Momentarily press the dial to activate the digital
Figure 2-3 illustrates the user interface on the Advanced
Digital Control.
The controller is factory-set and should not require
configuration or adjustment under normal operating
conditions. If the generator set is reconnected to a
different voltage and/or frequency, refer to an authorized
Kohler distributor/dealer for system configuration and
adjustment instructions.
Note: Have setup and adjustments of the Advanced
Digital Control performed only by an authorized
Kohler distributor/dealer.
1
display if dark.
D Rotate the dial to navigate through the main
D
D
D
2
D
5
Engine Start/Stop Button. The Engine Start/Stop
button toggles the running state of the engine. When the
controller is off, it has no effect. When the controller is in
a low-power mode, the Engine Start/Stop button starts
the engine. When the controller is in a low-power mode,
the button may need to be pressed twice to start the
engine.
4
3
1.
2.
3.
4.
5.
menus—turn clockwise to go forward (down) and
counterclockwise to go back (up). The menus do not
wrap to the beginning.
Press the dial at a given main menu to access the
submenus within the selected main menu.
When in the submenu, rotate the dial to navigate
through the submenu—clockwise to go forward
(down) and counterclockwise to go back (up). The
menus do not wrap to the beginning.
Momentarily press the dial when in the submenu to
make a user selection choice (if available) or to go
back to the respective main menu.
After about 5 minutes of no user input (pushbutton/
rotary selector dial or buttons), the menu resets to the
top of the main menus and auto-paging activates for
the Overview submenus.
LCD digital display
Pushbutton/rotary selector dial
Engine start/stop button
Power button
LED status indicator
GM58225A
Figure 2-3 Advanced Digital Control IId
2.6.1
Controls and Indicators
LCD Digital Display. The LCD digital display is backlit
any time the generator set is running or for at least
5 minutes after a user manipulates a button or the
pushbutton/rotary selector dial. The LCD displays
generator status, run time hours, fault shutdowns, and
fault warnings.
Pushbutton/Rotary Selector Dial.
This control
provides access to the menus for monitoring. Press the
selector dial to activate the digital display and to select
choices shown on the display. Rotate the dial to
navigate through the menus.
TP-6772
2/14b
Power Button. The Power button toggles the controller
between on and off. When the controller is off, it does
not respond to any input except the Power button.
Note: After about 5 minutes of no user input
(pushbutton/rotary selector dial or buttons), the
menu is reset to the top of the main menus and
auto-paging activates for the Overview
submenus.
Note: Measurements display in metric or English units.
Use the Generator Set System menu to change
the measurement display.
LED Status Indicator. The LED provides a summary of
the generator state. Figure 2-4 shows the possible LED
displays. When two or more colors are shown, the LED
blinks between the two colors in 2-second intervals. The
2nd and 3rd (if any) colors are shown for 100 ms each
and the 1st color appears for the remainder of the time.
Section 2 Operation
17