Download Glow worm Hideaway 50 - Direct Heating Spares

9.7 Pilot Burner
Follow the instructions in the relevant parts of Section 8.1 to
remove cover and burner controls assembly.
CAPILLARY
ELECTRICAL
CONNECTIONS
5041
9 Replacement of Parts
Remove the lint arrester as in Section 8.2.
Disconnect the thermocouple nut at the pilot burner, see diagram
9.3.
Disconnect the nut retaining the pilot tube and injector in the
pilot burner.
FLUE
BLOCKAGE
SAFETY
DEVICE
Remove the two screws and nuts securing the pilot burner and
the shield front cover, see diagram 9.3.
Check that the pilot flame length is as shown in diagram 7.3.
Replace thermostat phial as Section 8.1.
Replace lint arrester as Section 8.2.
9.8 Insulation Panels
Follow the relevant instructions in Section 8.1.
Unfasten the two screws retaining each side insulation panel
within the combustion chamber and remove panel, see diagram
9.5.
SECURING
LOCKNUT
Release the rear insulation panel upper clips and lift out panel.
Replace thermostat phial as Section 8.1.
9.9 Injector
When the burner has been removed from the injector manifold
as in Section 8.2 the injector can be unscrewed from the
manifold and renewed as necessary.
When replacing use a little jointing compound on the external
threads only, to make a gas tight seal.
Diagram 9.6
CABLE CLIPS(2)
REAR
INSULATION
PANEL
SIDE
INSULATION
PANEL
1670
CAPILLARY
0904/A
ELECTRICAL CONNECTIONS
Replace thermostat phial as Section 8.1.
CLIP
FLUE
BLOCKAGE
SAFETY
DEVICE
BAFFLE
TRAY
SCREW
GRAPHITE
COATED
NUT
INSULATION PANELS
Diagram 9.5
CAPILLARY REMOVAL
19
Diagram 9.7
221808B