Download DXC-D30WS DXC

1-20
Fitting the Lens
In the case of the DXC-D30F/D30PF/D30K/D30PK
model, the lens is already fitted. In other cases, use the
following procedure to fit the lens.
1
Remove the retaining rubber
which prevents the lens mount
from coming loose, then raise
the lens fixing lever, and
remove the lens mount cap.
4
Using the triangular mark as a
guide, push the lens connector
into the LENS connector on
the camera head, until it clicks
into place. Fasten the cable
with the clamps.
Retaining rubber
LENS connector
2
With the lens fixing lever
turned fully counterclockwise,
push in the lens, aligning the
projection on the lens with the
cutout on the camera.
Lens fixing lever
If using a lens with a 6-pin connector
This camera head has a 12-pin LENS connector. If the
lens cable has a 6-pin connector, fit an adaptor cable:
LO-612 (manufactured by Canon) or ECF-124
(manufactured by Fujinon) or equivalent.
Fitting optional filters
Loosen the lens hood fixing screw to remove the lens
hood, then attach the filter.
Remove lens hood
Lens hood fixing screw
Align and push in.
Filter (optional)
3
DXC-D30WS/P(E)/V1
26
Supporting the lens, turn the
lens fixing lever fully
clockwise. Replace the
retaining rubber on the lens
mount.
Chapter 2
Fitting and Connections
Chapter 2 Fitting and Connections
27
Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
Lens mount cap
Triangular mark