Download Instruction Manual

Transcript
SettiDg the Beam. Thc best way of checking the setting
of the lamp is to stand the motor cycle in front of a liglr
coloured pall at a distance of about 25 feet. If lecessary,
slacken the bolts securing the headlamp and move the
lamp until, with the main driving light switched on, the
beam is projected straight ahead and pamllel with the
ground. With tbe lamp in this position, the height of the
beam cenfe on the wall should b€ the same as the height
ofthe centre of the headlamp from the ground.
Stop Ligbt Switcb. This is operated by the brake rod
tfuough a spring- It is desirable to see that any mud or
grease is periodically cleared away from the swiich and
the operating mechanism should be oiled occasionally
wirh thin oil.
Resr Stop Lamp- The red transparentplastic portion ofthe
lamp can b€ raken offby removing the two retaininB screws.
ReDlicement
Br
bs
..
..
..
No.
312
988
384
Lucas
Watts
30124
3
6/18
(itrdex)
WIRING CONNECTIONS FOR
B.S.A. HEADLAMP COWL
I
When this is packed as a loose item (i.e., not installed in
positioo on the fiont forks), it comprises an actual cowl
unit, with the threæ followitrg items attached to it:
The Main Svitcb. This is on the left-hand side, and has
seven teftinals, or binding posts, on its unde$ide
oumbered clockwise.
Speedometer Head. This has on its underside the connector for the s[æedometer light on the side adjacent to
the maitr switch, the other iterns being the contrcl fot the
speedometer t p and the actual drive. The lattgr passes
through the headlamp shell.
Airmete.. This is on the right, and has on its undercide
two tetuinals, the one next to the speedometer head being
the negative. and the othe. beiog the positive.
66
Fig.22. 'B' Model wiring diagtum
( neg.rtir)e
earth
*
early ntodels)