1
Download TK-3201 - Gould Electronics
Transcript
TK-3201 ADJUSTMENT Channel selector PTT (Push to Talk) switch Power switch/ Volume control Call key Antenna LED indicator Speaker/ microphone jacks Monitor key Adjustment points TX-RX unit (X57-697) Frequency (MHz) Component side view BPF PCTV BATT+ 5M CN13 ANT B 5C TX-RX unit Component side view VR1 SP+ CV SB SP– VR1 : Frequency adjustment BPF : Band-pass wave form test point CV : VCO lock voltage adjustment terminal Foil Side View S401 PTT S403 SW1 S402 SW2 TX-RX unit Foil side view TC1 J301 EXT. SP/EXT. MIC CV TC1 : Transmit VCO lock voltage adjustment CV : VCO lock voltage adjustment terminal Fig. 1 Adjustment points ■ Frequency and signalling The set has been adjusted for the frequencies shown in the following table. When required. re-adjust them following the adjustment procedure to obtain the frequencies you want in actual operation. Channel No. 1 2 3 4 5 6 7 8 RX Frequency 446.00625 446.01875 446.03125 446.04375 446.05625 446.06875 446.08125 446.09375 TX Frequency 446.00625 446.01875 446.03125 446.04375 446.05625 446.06875 446.08125 446.09375 RX None None QT 67.0Hz QT 151.4Hz QT 250.3Hz DQT D023N DQT D754I TX None 100Hz Square Wave QT 67.0Hz QT 151.4Hz QT 250.3Hz DQT D023N DQT D754I Signalling Signalling No. 1 2 3 4 5 6 7 • Preparations for tuning the transceiver Before attempting to tune the transceiver, connect the unit to a suitable power supply. Whenever the transmitter is tuned, the unit must be connected to a suitable dummy load (i.e. power meter). The speaker output connector must be terminated with a 8Ω dummy load and connected to an AC voltmeter and an audio distortion meter or a SINAD measurement meter at all times during tuning. Adjustment Frequency TEST CH 1 2 3 4 5 6 7 8 RX Frequency 446.00625 MHz 446.01875 MHz 446.03125 MHz 446.04375 MHz 446.05625 MHz 446.06875 MHz 446.08125 MHz 446.09375 MHz TX Frequency 446.00625 MHz 446.01875 MHz 446.03125 MHz 446.04375 MHz 446.05625 MHz 446.06875 MHz 446.08125 MHz 446.09375 MHz 21
