Download Manual

Note:
To use TRAKPRO™ software with the DUSTTRAK™ Aerosol Monitor,
the PC must be running Microsoft Windows ® and the computer must
have an available Universal Serial Bus (USB) port.
1. Insert the TRAKPRO™ Data Analysis Software CD into the CD-ROM
drive. The install screen starts automatically.
Note:
If the software does not start automatically after a few minutes,
manually run the program listed on the label of the CD using
the Run command on the Windows Start Menu.
2. Follow the directions to install TRAKPRO™ software.
TRAKPRO™ software contains a comprehensive installation guide. It is
recommended to print out this prior to starting the TRAKPRO™ software
installation on your computer, so it may be consulted during the installation.
The TRAKPRO™ Software manual is located in the “Help” file in
TRAKPRO™ software. There is no separately printed TRAKPRO Data
Analysis software manual.
Connecting Analog/Alarm Output
The Analog/Alarm Output Cable plugs into the alarm connection on the side
of the instrument. This feature is on the desktop models (8530/8531) only.
The cable contains a 4-pin, mini-DIN connector. The pin-outs for the
connector and the wiring for the cable are shown below.
®
Microsoft and Windows are registered trademarks of Microsoft Corporation.
Setting Up
11