Download Tecumseh / Peerless Motion Drive System

Main Menu
BEVEL SPUR GEAR
TABS IN
SLOTS
TORQUE SCREWS
70-90 IN. LBS
SHIFTER
PLATES (2)
SPACER
PLATE
REMOVE BEARING
AND SPROCKET
COLLAR MUST FACE
BEVEL SPUR GEAR
COUNTERSHAFT
BEVEL SPUR GEAR
BUSHING
ANGLE
SHAFT
TOGETHER
HERE
CHAIN
SPACER
Install shifter assembly, 12 oz. Bentonite grease around
gearing, and reinstall cover on case. Torque cap screws
90-110 in. lbs.
To put tension on the index ball, spring and set screw.
Tighten down to flush then two (2) turns in below flush.
Check for binding by turning input shaft. Install
transmission on equipment. Install brake and linkage
and adjust to disengage when clutch is engaged.
Consult equipment Owner’s Manual.
SHOULDER
APPLY LUBRIPLATE
With collar on countershaft sprocket facing the bevel
spur gear, install sprocket onto serration and install
chain. Install all (4) thrust washers, MUST be positioned
on the shifting gear of the output shaft.
BRAKE
BRACKET
SPACER
NOTCHES
NOTCHES
SPACER
Install bronze bearings and disc and sprocket. Install
shaft assemblies into case utilizing piloting locators
on bearings to properly align notches in case. CAUTION:
Be sure bearing locators are seated in transmission
case.
Apply a light film of lubriplate to the inside of lever
portion which contacts pins, also to outside of lever
which contacts flat washer and between shaft O.D.
and bore of brake disc. Brake pads and brake disc
must be free of grease and oil.
Brake and linkages may vary.
NOTE: If adjusted incorrectly, the brake will do one of
two things;
a. It will not brake (stop) the vehicle when the
brake is applied, or
b. If adjusted too tightly, a drag or continued braking
effect will be evident until the brake wears out.
19