Download PLOTE CONSTRUCTION INC

Transcript
MACHINERY LOADING, UNLOADING OR TRANSFERRING
1.
In the loading or unloading of machinery onto or from trucks, floats or freight cars, take special
precautions. Only experienced personnel will be allowed to supervise the moving of such
machinery.
2.
Stand clear of machinery when it is being unloaded or transferred from one level to another. Ensure
that loading ramps are of adequate width to accommodate passage of machinery onto or from
trucks, trailers, or freight cars.
3.
Machinery being transported on a float or any other vehicle must be securely blocked and tied down
to prevent movement. Where it overhangs either the sides or end of the vehicle, you must display
warning flags by day and lights at night.
4.
Before hauling or tramming a machine, check the manufacturers manuals for proper procedures to
be followed.
5.
When transporting over public roads, always secure the necessary permits. Make provisions for
warning the public and controlling traffic. Clean up mud or other road hazards created by the
movement of equipment before removing your warning signs or leaving the area.
LOADING & UNLOADING IN GRAVEL PITS & YARDS
1.
Drivers must sign in at scale.
2.
Observe all traffic signs, signals and posted speed limits.
3.
Drivers and passengers must remain in their vehicle; our loader operators have been instructed
not to load a truck unless the driver is observed in the driver’s seat.
4.
Always yield right-of-way to mobile equipment
5.
Do not follow any vehicle too closely.
6.
Park only in designated parking areas. Safety equipment including hard hats, safety glasses
and steel-toed shoes must be worn if you are going to exit your truck in these areas.
7.
Check behind your vehicle before backing up.
8.
Do not smoke or use open flames around flammable liquid storage or dispensing areas, or other
potential fire hazards. Obey all “No Smoking” signs.
9.
Never stand near bins, hoppers or stockpiles where material could slide and strike or bury you.
10.
Do not attempt to get on or off moving equipment.
11.
No acts of violence or “horseplay” will be tolerated.
12.
First Aid supplies are located throughout the property. If you are injured or involved in an
accident while on the property, report it promptly to plant supervision.
13.
Report any unusual conditions to a Company supervisor promptly.
14.
Alcoholic beverages and narcotics are prohibited on Company property.
15.
Lower truck beds before driving away.
16.
In case of an emergency, dial 911.
DRIVER EQUIPMENT INSPECTION REPORT
Inspection reports must be filled out daily. All mechanical defects must be reported on "Driver's Equipment
Inspection Reports" which are located in the driver's room--these reports must be legible and concise. The
reports must include: driver's name, truck or tractor number, trailer, mileage on tractor, and date of report.
WORK SHEETS
Before leaving the yard in the morning, be certain that you have the necessary trip sheets and tickets to
record your work for the day. It is extremely important that all boxes be filled out completely and accurately
on these sheets. Any work sheet not filled out completely and accurately will be returned to the driver and
not accepted until corrected. It must be turned in at the end of the day - if office is locked, place it in the
mailbox outside of the dispatch office.
VALID LICENSE
Employees possessing a valid driver’s license may be authorized by their supervisor to operate a Company
vehicle. Drivers must have in their possession a valid C.D.L. and a current D.O.T. physical/medical card at
all times while operating our vehicles. Spot checks will be made of all C.D.L.'s and physical/medical cards,
5